Drift Dual Brake Calipers Adapters weld-on for BMW E36 E46 E39 E83

Need an extra caliper in the rear brake set up? Look no further than the Bevinsee Twin caliper mounting brackets. Designed to allow the mounting of an additional factory rear caliper to the trailing arm for a true drift setup.

Features:

• 0.5"/12mm of High-Strength Steel Material.
• These welded plates are only compatible with BMW E36, excluding Compact and E46 calipers, as well as suspension arms of disc brakes.
• Can be equipped with a pair of additional rear brake calipers. This solution is ideal for drifting, and hydraulic handbrakes can be installed on separate and independent hydraulic circuits.

Item Specifics:

• Condition: New
• Type: Dual Brake Calipers Adapters
• Material: High Quality Steel

Note:

• Removal of ABS sensor is required.
• Original caliper from a similar car (with the same engine / brake disc size) must be used.
• Will require trimming of the brake dust shield to properly install caliper.

Fitment:
For all E36 rear trailing arms ( excluding Compact )
For all E46 rear trailing arms( excluding Compact )

BMW E39 520i/523i/525i/530i (M52/M52TU/M54 Engine)

BMW E83 25i/30i (PreLCI M54 Enigne)

Bevinsee parts are not sponsored or endorsed by, or affiliated with the brands its parts fit, including Porsche, Subaru, Jaguar, BMW, Isuzu, Chrysler, Dodge, Jeep, Buick, Cadillac, Chevrolet, GMC, Volvo, Land Rover, Oldsmobile, Pontiac, Ford, Lincoln, Mercury, Acura, KIA, Nissan, Infiniti, International Harvester, Mitsubishi, Audi, Lexus, Toyota, Mazda, Volkswagen, Suzuki, Saab, Honda, Alfa Romeo, Saleen, Mercedes-Benz, Nash, Hummer, Freightliner, Datsun, Saturn, Turner, Geo, Lada, Fiat, Daihatsu, Opel, Vauxhall, Sabra, Tesla, Ram, Rover, Skoda, Healey, Mini, Smart, Scion, Renault, Seat, Peugeot, Merkur, Astra, Tucker, VW, Routan, Tiguan, Touareg, Jetta, Gti, Passat, Golf, Bosch, Denso, Holden, Chery, Mercedes Benz, Holden Special Vehicles, Hyundai, Trabant, Citron, Freightline, etc.