Rust-Oleum Epoxyshield Blacktop Coating - Jet Black

Sealing your blacktop in no longer a messy, smelly chore thanks to Rust-Oleum EPOXYSHIELD Blacktop Shield. This revolutionary, low-odor coating made from recycled tires applies like paint and cleans up with soap and water. Plus is drive-ready in just four hours.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of the Product

• Lasts longer than conventional asphalt coatings.
• Fast drying / drive ready in 4 hours.
• Formulated with recycled rubber tires.
• Stirs like paint, rolls like paint.
• 1 two gallon bucket of EPOXYSHIELD Blacktop Coating = two 5 gallon buckets of conventional asphalt coating.

How to Apply Epoxyshield Blacktop Coating

Surface Preparation

Clean the entire driveway surface of any dirt, debris, oil and grease spots. Trim any grass or weeds overgrowing onto the driveway. Scrape clean all cracks and holes using a screwdriver or wire brush. Remove remaining dirt, dust and debris by sweeping with a stiff broom. Clean heavy grease or oil spots with EpoxyShield Blacktop Cleaner & Degreaser (sold separately). Thoroughly rinse driveway with fresh water and allow the surface to dry before application.

Note: Newly paved asphalt surfaces must be allowed tocure for a minimum of six months or a full summer season prior to application of any coating.

Application

Apply when air and surface temperatures are between 50- 90°F (10-32°C). The surface temperature should not exceed 100°F (38°C) and no rain is forecasted for 48 hours. Do not use when the surrounding air and surface temperatures fall below 40°F (4°C). Do not dilute. Avoid applying coating in direct sunlight. If pavement is extremely hot, apply a fine water mist prior to coating. Brush out any remaining water puddles.

Properties of Epoxyshield Blacktop Coating

Surface Preparation Clean the entire driveway surface of any dirt, debris, oil and grease spots. Trim any grass or weeds overgrowing onto the driveway. Scrape clean all cracks and holes using a screwdriver or wire brush. Remove remaining dirt, dust and debris by sweeping with a stiff broom. Clean heavy grease or oil spots with EpoxyShield Blacktop Cleaner & Degreaser (sold separately). Thoroughly rinse driveway with fresh water and allow the surface to dry before application. Note: Newly paved asphalt surfaces must be allowed tocure for a minimum of six months or a full summer season prior to application of any coating. Application Apply when air and surface temperatures are between 50- 90°F (10-32°C). The surface temperature should not exceed 100°F (38°C) and no rain is forecasted for 48 hours. Do not use when the surrounding air and surface temperatures fall below 40°F (4°C). Do not dilute. Avoid applying coating in direct sunlight. If pavement is extremely hot, apply a fine water mist prior to coating. Brush out any remaining water puddles. Properties of Epoxyshield Blacktop Coating Manufacturer Rust-Oleum Resin Type Vinyl Acrylic Pigment Type Carbon Black Dispersion Solvent Water Weight 7.56 Ltr. Volatile Organic Compounds <50 g="" l="" 0="" 42="" lbs="" gal="" td=""> Practical Coverage at Recommended DFT 400-600 sq.ft./ bucket Dry Times at 70-80°F(21-27°C) and 50% RH 1 hour to Walk Ready 4 hours to Drive Ready Shelf Life 3 years Flash Point >200°F (93°C) Technical Data Sheet Click here