Rust-Oleum FinishKote 80 High Solids Polyaspartic Floor Coating - Part A

"

FinishKote 80 is a two component, high gloss, UV stable polyaspartic polyurea floor coating for use in industrial and commercial facilities. Suitable for both interior and exterior applications. FinishKote 80 can be used as a clear finish or tinted to finish color.

NOTE: It is not allowed to send this item through air mode. Surface mode is enabled for the same. Thus, shipping will be done through surface.

Features of FinishKote 80 High Solids Polyaspartic Floor Coating - Part A

• Can be applied by spray or roller at temperatures between -20-120 F and in high humidity
• Fast dry coating can be top coated in 4-6 hours
• Provides excellent adhesion to concrete, epoxies, urethanes and polyureas
• Dries to a high gloss, professional finish

How to Apply FinishKote 80 High Solids Polyaspartic Floor Coating Part - A

Surface Preparation

The concrete surface must be free of all dirt, grease, oil, fats, and other contamination. Remove surface contamination by cleaning with Pure Strength 3599 Industrial Cleaner/Degreaser, detergent, or other suitable cleaner. Rinse thoroughly with clean, fresh water and allowed to dry.

Application

Apply only when air, material and floor temperatures are between -20 - 120°F (-29 - 32°C). Do not apply in direct Sunlight or when temperature is rising. Immediately after mixing, pour the material onto the floor in a long, 8 to 12 inch wide stripe.

Properties of FinishKote 80 High Solids Polyaspartic Floor Coating - Part A

Surface Preparation The concrete surface must be free of all dirt, grease, oil, fats, and other contamination. Remove surface contamination by cleaning with Pure Strength 3599 Industrial Cleaner/Degreaser, detergent, or other suitable cleaner. Rinse thoroughly with clean, fresh water and allowed to dry. Application Apply only when air, material and floor temperatures are between -20 - 120°F (-29 - 32°C). Do not apply in direct Sunlight or when temperature is rising. Immediately after mixing, pour the material onto the floor in a long, 8 to 12 inch wide stripe. Properties of FinishKote 80 High Solids Polyaspartic Floor Coating - Part A Manufacturer Rust-Oleum Resin Type Polyaspartic Polyurea Solids By Volume 80% Volatile Organic Compounds <10 g="" l="" td=""> Mixing Ratio 1:1 (Part A to Part B) Induction Time None required Pot Life 20-25 minutes Practical Coverage at Recommended DFT 250-350 sq.ft./3.78 Ltr. Coverage rate can vary depending on the texture and porosity of the concrete Dry Times at 70-80° (21-27°C) and 50% RH 1-2 hours to Tack Free 2-4 hours, 24 hours for vehicle traffic to Dry Hard 4-12 hours* to Re-Coat Shelf Life 12 months Safety Information For additional information, see MSDS Technical Data Sheet Click here